Why we built our own Teachbot

TOS Robotics built its own Teachbot because the off-the-shelf arm it first used to teach robots was too coarse. One count of that arm's 12-bit encoders became a 0.35 degree step of the robot's wrist, so fine corrections by hand were lost. The Teachbot has 17-bit encoders, 32 times finer, and passive joints of 57 g.

First setup

In January 2024 our first teleoperation rig, for steering a robot by hand in real time, used an off-the-shelf research arm as the leader. An engineer moved the leader and a FANUC robot followed. The leader’s joints were small servo motors with 12-bit encoders, 4,096 counts per turn, read through the robot software framework ROS at 50 samples per second. Its forearm roll joint was locked, so we taught with five joints instead of six, and the robot’s wrist turned four times as far as the leader’s to get enough range.

What went wrong

With the wrist gain of four, one count on the leader moved the robot’s wrist 0.35 degree. At the robot’s full reach of 911 mm, one count of the base joint moved the tool about 1.4 mm. The PC sent a new target every 4 ms, and we saw these steps as jitter, a small fast shaking. Corrections smaller than one count did not reach the robot. The servos also added weight and friction, which tire the hand during a long teaching session.

What we changed

In February 2025 we tested the first joint of our own, built around a 17-bit absolute magnetic encoder. Absolute means it knows its angle at power-up, without a homing move. Over four iterations that joint became the Teachbot.

The Teachbot is passive, so the joints have almost no friction. The segments are 15 mm carbon fibre tubes of 19 g each, and the joint housings are 3D-printed in resin with miniature bearings. A joint weighs 57 g, about six times lighter than our earlier design. The same joint module comes in a cobot layout and a FANUC layout.

The encoders send over RS-422, a serial link that resists electrical noise, into an Ethernet server at 500 samples per second per joint, without USB or ROS, see why we keep USB out of our robot cells.

Measure Leader arm (2024) TOS Teachbot (2025 on)
Counts per turn 4,096 (12 bit) 131,072 (17 bit)
Angle per count 0.088° 0.0027°
Robot wrist step per count 0.35° (gain 4) 0.008° (gain 3)
Tool step per count, base joint at full reach about 1.4 mm about 0.04 mm
Joints in use 5, forearm roll locked 6

Results

The robot follows the hand about 12 ms later. The encoder data reaches the PC in 2 to 3 ms at the median. The PC sends a joint target every 4 ms and plans the motion itself, because planning in the robot controller would add more than 100 ms. At rest, five of the six joints showed noise of 1 to 5 thousandths of a degree. In about 500,000 frames no encoder reported an error. In a pilot at a packer in the Netherlands, a new task was taught in one working day. More on the Teachbot page.

Questions and answers

Why are there no motors in the Teachbot?

We tried servo motors in each joint to carry the weight of the arm, called active gravity compensation. It felt less natural, needed extra control software and only worked with expensive servos, so we dropped it.

Who uses the Teachbot?

Engineers of TOS Robotics. They teach the robot new tasks with it, at our test cell or at the line of the packer.

See it run on your product

Send us your product and your packing format. We show you what the robot does with it, in simulation or on our test cell in Vught.

Request a demo